QUESTION 1
Which method of encryption does the 802.11i standard use?
A. AES/CCMP
B. AES/ECB
C. AES/OCB
D. TKIP
E. both AES/ECB and AES/CCMP
Answer: A
QUESTION 2
Which type of authentication is used initially by a controller-based AP so that a guest client can get an IP address?
A. 802.1x
B. EAP
C. LEAP
D. open authentication
E. TLS
F. SSL
Answer: D
QUESTION 3
What is the maximum number of lightweight APs that can be supported from a single Cisco WCS Navigator management console with Cisco WCS and Cisco WLC running version 7.0 code?
A. 10,000
B. 20,000
C. 25,000
D. 30,000
E. 60,000
Answer: D
QUESTION 4
Which two tasks does RRM routinely perform? (Choose two.)
A. antenna selection
B. AP address assignment
C. channel assignment
D. encryption method assignment
E. transmit power control
Answer: CE
QUESTION 5
Refer to the exhibit. Which two options does this icon represent about the status of the respective AP on a Cisco WCS version 7.0 map? (Choose two.)
A. The 802.11a/n radio is administratively disabled.
B. The 802.11a/n radio has a minor fault.
C. The 802.11a/n radio has a major fault.
D. The 802.11b/g/n radio is administratively disabled.
E. The 802.11b/g/n radio has a minor fault.
F. The 802.11b/g/n radio has a major fault.
Answer: CD
QUESTION 6
In general, what is the difference in transmit power between an AP operating at Tx Power Level 1 and the same AP operating at Tx Power Level 3?
A. 2 dB
B. 3 dB
C. 6 dB
D. 11 dB
E. 17 dB
Answer: C
QUESTION 7
Which two statements are true about WiMAX technology? (Choose two.)
A. WiMAX is defined by 802.11i.
B. Typically, fixed WiMAX networks have a higher gain direction antenna installed near the client.
C. WiMAX is capable of working as a long-range system over several miles.
D. WiMAX works only for licensed frequencies.
Answer: BC
QUESTION 8
Refer to the exhibit. Which menu gives you access to manage background tasks in Cisco WCS?
A. None, because the General tab provides access to the management of background tasks
B. Monitor
C. Configure
D. Services
E. Administration
F. Tools
Answer: E
QUESTION 9
What is the difference between the IEEE, the WiFi Alliance, and the FCC, ETSI, and TELEC?
A. The IEEE and FCC are responsible for the standards that apply to wireless networks. The WiFi
Alliance, ETSI, and TELEC are the governmental agencies that regulate compliance with local
standards.
B. The IEEE is responsible for Layer 1 and Layer 2 protocols. The WiFi Alliance is responsible for
interoperability testing. The FCC, ETSI, and TELEC are responsible for radio frequency and
transmission power-level regulations and standards in the U.S., Europe, and Japan.
C. The IEEE is responsible for Layer 1 and Layer 2 protocols. The FCC, ETSI, and TELEC are
responsible for interoperability testing and compliance. The WiFi Alliance is responsible for radio
frequency and transmission power-level regulations and standards on a global basis.
D. The IEEE and FCC are responsible for the Layer 3 protocol support and frequency and power- level
regulations in the United States. ETSI and TELEC are responsible for frequency and power- level
regulations in Europe and Japan. The WiFi Alliance is responsible to interoperability testing.
Answer: B
QUESTION 10
You are testing a new autonomous Cisco Aironet 1260 AP that has booted for the first time on the existing corporate network, which includes voice, data, and location services.
How do you reach the GUI of the AP?
A. HTTP to 10.0.0.1.
B. HTTP to 192.168.1.1.
C. HTTP to the DHCP address.
D. HTTPS to 10.0.0.1.
E. HTTPS to the 192.168.1.1.
F. HTTPS to the DHCP address.
Answer: C
If you want to pass Cisco 640-722 successfully, donot missing to read latest lead2pass Cisco 640-722 dumps.
If you can master all lead2pass questions you will able to pass 100% guaranteed.
